Mobile crushing line

Hot selling equipment


An Experimental study on Crushed Stone Dust as Fine ...

2018-1-1  The deficit of natural sand arise the need of alternative materials for replacement of natural sand. This experimental study explores in detail the crushed stone dust which is locally available industrial solid waste material in India as alternative material to natural sand that is being conventionally used as fine aggregate in cement concrete.

Get Price

Replacement of Coarse Aggregate by Using Naturally ...

2019-7-1  Fineness Modulus Water Absorption (%) 1690 2.75 3.96 1.8 Crushed Fine Aggregate Crushed fine aggregate (CFA) are crushed fine basalt rock. used for this entire investigation for concrete was manufactured sand conforming to zone-I of IS: 383-1970. TABLE VIII. PROPERTIES OF SAND (CRUSHED SAND) Bulk Density(gm/m3) Specific Gravity Fineness Modulus

Get Price

Experimental Investigation on Partial Replacement of Fine ...

2017-2-4  partial replacement of fine aggregate by crushed brick and recycled Limestone powder. In this project sand can be replaced by 10, 20 30% of brick powder and also sand replaced by Limestone powder range was 10, 15 20% in M20, M25M30 mix ratio. The optimum replacement of Limestone and brick was found to be 15% and 20%

Get Price

Utilization of Stone Dust as Fine Aggregate Replacement

2015-4-30  Stone dust is to be used as partial or full replacement of natural fine aggregate in concrete. The use of stone dust in concrete is beneficial in different manner such as environmental aspects, non-availability of good quality of fine aggregate, strength criteria etc.

Get Price

An Experimental Study on Partial Replacement of Sand

2016-3-3  of 40% replacement of stone dust with 2% Superplasticizer is equal to the workability of conventional concrete. Workability is ... crushed stone dust as fine dust and found that flexural strength increases than the concrete with natural sand but the values ... 7 Fineness modulus - 2.3 2.42 2.70 ...

Get Price

(PDF) Stone Dust as Fine Aggregate Replacement in Concrete ...

percent replacement of fine aggregate with stone dust in concrete. Re sults shows natural sand can be effectively replace with stone dust and maximum strength attains at 60 percent replacement of...

Get Price

Suitability of Crushed Cow Bone as Partial Replacement of ...

2017-1-31  Using CCB as partial replacement of sand can result in different types of concrete based on the density attainable. The compressive strength of the specimens decreased with an increase in the percent replacement of sand with crushed cow bone. The compressive strength of the specimens increasedwith curing ages.

Get Price

Suitability of Crushed Manufactured Sand for

2020-11-28  economy [5,6]. Fine aggregates generally consist of natural sand or crushed stone with most particles smaller than 5 mm (0.2 in.). Natural sand is mainly excavated from river beds and always contains a high percentage of impurities that adversely affect the properties of concrete by reducing the life of the structure [7].

Get Price

AN EXPERIMENTAL INVESTIGATION ON THE STRENGTH

2017-11-15  The Split Tensile Strength at 28 days for 20% Stone Dust replacement in OPC is observed as 3.335 MPa. The Split Tensile Strength at 28 days for 20% Stone Dust replacement in OPC and 50% replacement of Crushed fine aggregate in Fine Aggregate is observed as 3.46MPa. 8.3 Flexure Strength

Get Price

Vol. 5, Issue 9, September 2016 Study on Compressive ...

2020-11-30  aggregate replacement in concrete. The optimum percentage for replacement of stone dust with fine aggregate along with 20% replacement of coarse aggregate by ceramic waste was found to be 40%. Umapathy U, Mala C, SivaK (2014) did assessment of concrete strength using partial replacement of coarse aggregate

Get Price

Replacement of Coarse Aggregate by Using Naturally ...

2019-7-1  Fineness Modulus Water Absorption (%) 1690 2.75 3.96 1.8 Crushed Fine Aggregate Crushed fine aggregate (CFA) are crushed fine basalt rock. used for this entire investigation for concrete was manufactured sand conforming to zone-I of IS: 383-1970. TABLE VIII. PROPERTIES OF SAND (CRUSHED SAND) Bulk Density(gm/m3) Specific Gravity Fineness Modulus

Get Price

An Experimental study on Crushed Stone Dust as Fine ...

2018-1-1  The deficit of natural sand arise the need of alternative materials for replacement of natural sand. This experimental study explores in detail the crushed stone dust which is locally available industrial solid waste material in India as alternative material to natural sand that is being conventionally used as fine aggregate in cement concrete.

Get Price

Utilization of Stone Dust as Fine Aggregate Replacement

2015-4-30  replacement of natural sand (Pofale et al 2013).The present study aimed to utilizing stone dust as fine aggregate in concrete in place of natural fine aggregate. For that an experimental programme was carried out to study the suitability and potential use of stone dust as partial replacement of fine aggregate in concrete.

Get Price

Suitability of Crushed Cow Bone as Partial Replacement of ...

2017-1-31  crushed clay bricks, bottom ash, laterite, etc. (Falade et al., 2013a, Mathews et al., 2013, Dahiru and Usman, 2013, Ashiquzzaman and Hussein, 2013, Ganiron Jnr, 2013, Raju et al., 2014, and Otoko, 2014). The present study investigated the use crushed cow bone (CCB) as a partial or full replacement of fine aggregates in the

Get Price

Use of Quarry Dust to Replace Sand in Concrete – An ...

2021-6-4  Crushed granite stone Maximum size : 20 mm Specific gravity : 2.98 Fineness modulus : 6.36 Density : 1.58gm/cc River sand Specific gravity : 2.53 Fineness modulusC : 3.08 Density : 1.63gm/cc Void ratio : 0.55 Quarry dust Specific gravity : 2.57 Fineness modulus : 2.41

Get Price

Suitability of Crushed Manufactured Sand for Replacement ...

Jadhav, Priyanka A and Dilip K. Kulkarni. “Effect of replacement of natural sand by manufactured sand on the properties of cement mortar.” Int J Civ Struct Eng (2013) 3. Lakhan Nagpal, Arvind Dewangan, Sandeep Dhiman and Sumit Kumar (2013). “Evaluation of Strength Characteristics of Concrete Using Crushed Stone Dust as Fine Aggregate.”

Get Price

AN EXPERIMENTAL INVESTIGATION ON THE STRENGTH

2017-11-15  Abstract - In the present study Stone Dust is used as partial replacement of cement by weight at varying percentages i.e.10%, 20%, 30% respectively. Crushed fine aggregate is used as replacement of fine aggregate by weight at varying percentages i.e. 25%, 50%, 75% 100% respectively. The combined influence of Stone Dust and Crushed fine aggregate

Get Price

PARTIAL REPLACEMENT OF NATURAL RIVER SAND WITH

2015-10-30  The use of crushed rock sand as a partial replacement of river sand in concrete production was and 0.59 for 0 % to 100 % natural sand replacement. The slump ranged between 49 and 60 mm for 0 % to 100 % natural sand replacement. N/mm2. The effective natural sand (RS) replacement ranged between 0 and 60 % with the best results achieved at 20 %

Get Price

Suitability of Crushed Manufactured Sand for

2020-11-28  economy [5,6]. Fine aggregates generally consist of natural sand or crushed stone with most particles smaller than 5 mm (0.2 in.). Natural sand is mainly excavated from river beds and always contains a high percentage of impurities that adversely affect the properties of concrete by reducing the life of the structure [7].

Get Price

Vol. 5, Issue 9, September 2016 Study on Compressive ...

2020-11-30  aggregate replacement in concrete. The optimum percentage for replacement of stone dust with fine aggregate along with 20% replacement of coarse aggregate by ceramic waste was found to be 40%. Umapathy U, Mala C, SivaK (2014) did assessment of concrete strength using partial replacement of coarse aggregate

Get Price

Replacement of Coarse Aggregate by Using Naturally ...

2019-7-1  Fineness Modulus Water Absorption (%) 1690 2.75 3.96 1.8 Crushed Fine Aggregate Crushed fine aggregate (CFA) are crushed fine basalt rock. used for this entire investigation for concrete was manufactured sand conforming to zone-I of IS: 383-1970. TABLE VIII. PROPERTIES OF SAND (CRUSHED SAND) Bulk Density(gm/m3) Specific Gravity Fineness Modulus

Get Price

Use of Quarry Dust to Replace Sand in Concrete – An ...

2021-6-4  Crushed granite stone Maximum size : 20 mm Specific gravity : 2.98 Fineness modulus : 6.36 Density : 1.58gm/cc River sand Specific gravity : 2.53 Fineness modulusC : 3.08 Density : 1.63gm/cc Void ratio : 0.55 Quarry dust Specific gravity : 2.57 Fineness modulus : 2.41

Get Price

PARTIAL REPLACEMENT OF NATURAL RIVER SAND WITH

2015-10-30  The use of crushed rock sand as a partial replacement of river sand in concrete production was and 0.59 for 0 % to 100 % natural sand replacement. The slump ranged between 49 and 60 mm for 0 % to 100 % natural sand replacement. N/mm2. The effective natural sand (RS) replacement ranged between 0 and 60 % with the best results achieved at 20 %

Get Price

EXPERIMENTAL INVESTIGATION ON PARTIAL

2021-8-17  with 0%, 25%, 50%, 75% and 100% replacement to crushed stone aggregate were considered during this study. the combination proportion was done as per ASTM (2005). The properties of fresh and hardened concrete were studied on the mixes considered. The results showed that there's a rise in slump value and strength properties.

Get Price

Suitability of Crushed Manufactured Sand for

2020-11-28  economy [5,6]. Fine aggregates generally consist of natural sand or crushed stone with most particles smaller than 5 mm (0.2 in.). Natural sand is mainly excavated from river beds and always contains a high percentage of impurities that adversely affect the properties of concrete by reducing the life of the structure [7].

Get Price

Influence of stone dust as fine aggregate replacement on ...

2018-6-7  with 70% of replacement there was a reduction of 30% in relation to reference due to the shape of lamellar artificial sand. In addition, for the same replacement content the increased resistance was of the order of 56%. Çelik et al.,7 carried out an experimental program in order to investigate the influence replacement of natural sand by stone ...

Get Price

Fundamental Characteristics of Concrete According to ...

2015-9-30  The paper evaluates the effect of the physical property, fineness modulus (FM) and replacement ratio of crushed sand on the characteristics of concrete. This is intended to use crushed sand from Daegu-Kyungbuk region as the fine aggregate of concrete.

Get Price

Suitability of Crushed Manufactured Sand for Replacement ...

Jadhav, Priyanka A and Dilip K. Kulkarni. “Effect of replacement of natural sand by manufactured sand on the properties of cement mortar.” Int J Civ Struct Eng (2013) 3. Lakhan Nagpal, Arvind Dewangan, Sandeep Dhiman and Sumit Kumar (2013). “Evaluation of Strength Characteristics of Concrete Using Crushed Stone Dust as Fine Aggregate.”

Get Price

The Utilization Of Crushed Stone Dust As A Replacement Of ...

If it is possible to utilizing this crushed stone dust as a partial ijera DOI: 10.9790/9622-0809031114 11 P a g e Mr.A.C.Dubal Journal of Engineering Research and Application ijera ISSN : 2248-9622, Vol. 8, Issue 9 (Part -III) Sep 2018, pp 11-14 replacement of river sand in making quality utilization of crushed stone dust we ...

Get Price

A BRIEF STUDY ON THE STRENGTH PROPERTIES OF

2019-4-21  ratio of 0.50. Wood ash replacement is done in 0, 5, 10, 15, 20 and 25% to cement and in place of natural fine aggregate crushed stone sand has been used in the present study. 150×150×150 mm cubes and 150 mm diameter and 300mm height cylinders were

Get Price